Updated November 2026
Removing solar panels for roof repair is necessary whenever a repair or replacement is happening under the array, because the panels, racking and rail hardware sit on top of the shingles or roofing material that needs access. Small patches can sometimes be done around the array, but anything involving underlayment, flashing or full replacement almost always means the panels come off first. Plan for the removal to be done by a qualified installer, and check your system’s paperwork before anyone unbolts a single panel.
Why the Panels Have to Come Off
Solar racking is attached to the roof deck through lag bolts or standoff feet that pierce the roofing and seal around the penetrations. Those mounts sit under the flashing and above the shingle courses, so a roofer working on those areas has no clean way to reach the surface beneath. Even when the panels themselves look fine, the rails and feet block nails, tear-off equipment and underlayment work. Removing the modules also keeps the heavy array off a deck that may be softened or damaged in the repair zone.
Shopping for one? See our guide: Removal of Solar Panels for Roof Repair: Top 3 Tools and Kits Compared (2026).
Factors That Decide How the Job Is Done
The scope of the removal depends on a few things you can check before the crew arrives:
- Roof section affected. A repair on one slope may only require pulling panels from that plane, while a full reroof means the whole array comes down.
- Mounting type. Rail-based systems with penetrating lag bolts take longer to remove than some ballasted or clamp-based systems, which may need less disassembly.
- Wiring and inverter. Every module is wired into strings. A licensed electrician must shut down the system at the disconnects, confirm the circuits are de-energized, and disconnect the strings before any panel leaves the roof.
- Permits and utility notice. Some jurisdictions and utilities require notice or a reinspection when the system is taken offline and reinstalled. Check your interconnection agreement.
- Age of the panels and hardware. Old connectors and brittle cable may need replacing during reinstallation, which adds time and parts.
How to Plan the Removal and Reinstall
Good planning keeps the array from sitting on a stripped roof longer than necessary. Use this sequence as a starting point, and confirm each step with your installer:
- Get a written scope from the roofing contractor and the solar installer that names exactly which panels and rails come off.
- Ask the solar company to schedule the electrical shutdown and disconnect before the roofers arrive.
- Photograph the array layout, string wiring and rail positions so reinstallation matches the original design.
- Label each module and cable run, and store panels flat or upright on a protected surface away from foot traffic.
- Have the installer inspect rails, feet and connectors during reinstall, and replace any worn parts.
- Request a final inspection and confirm the system is back online and producing as expected.
Roofing and solar work both carry fall and electrical hazards. Hire licensed professionals, and consult a qualified electrician or structural professional if you have questions about the deck’s condition. For a broader walkthrough, see Roof Repairs with Solar Panels: A Step-by-Step Guide for Homeowners and Solar Panels on Roof Problems: 6 Issues to Check and Fix.
What We’d Use
If you plan to handle part of the work yourself, such as lifting and staging modules, a sturdy panel cart reduces the risk of cracked glass. Look for one with padded contact points.
For fastening and reinstalling mounts, a torque-rated impact driver with the correct sockets helps keep the lag bolts and rail clamps at the specified values.
FAQ
Do I have to remove the solar panels for every roof repair?
No. Minor repairs away from the array can often be done without removal. Any work that touches the flashing, underlayment or mounting area usually requires the panels to come off.
Who should take the panels down?
A licensed solar installer or electrician should handle the electrical shutdown and disconnect, and the same team or a qualified contractor should handle reinstallation.
Will my system stop producing power during removal?
Yes, the system will be offline while it is disconnected. Ask your installer how long the outage will last and whether your utility needs to be notified.
